I posted recently about wanting to install OpenWrt.
I just wanted to thank everybody who gave advice and encouragement. It was very quick and easy to setup.
I had some very small issues:
- I had to reboot my internet modem to get internet working. Duh.
- I initially didn’t put my country code for wifi, even though the docs say this is important. My bad.
- I initially set my wifi to WPA3, but I had to switch to WPA2 for my Roku. My bad for owning a Roku.
So far I’ve installed adblock and wireguard extensions, although I haven’t enabled the wireguard yet.
What other extensions do people recommend?
Thanks again!
And turns out if you lose you ssh key, you can just login using any string more than 256 characters. https://sshhole.com/
i believe openwrt uses dropbear by default instead of openssh
Love openwrt. AdGuard and WireGuard server running. So handy.
Reticulum! Runs nicely on open-wrt, and makes a better internet for everyone.
Especially good in this time of political strife where we see internet access being used as a political weapon by state actors.
I’ve seen this mentioned elsewhere but have never been clear on what exactly it does.
So basically, the internet runs on TCP/IP, which is provided by an ISP.
Reticulum is a new protocal in the same spot - it puts packets out.
However, while your TCP/IP address is usually tied to your location, and unencrypted, Reticulum is tied only to a cryptographic address. Which means that it can go anywhere, via any path - and is encrypted while it does so. Only you can unpack the packet and see what’s in it, so your ISP can’t spy on you, and it’s hard to block access.
And this also means it’s easier to work on different physical media - so Reticulum can work over LoRA (low wattage) radios, that are similar to walkie talkies in power and don’t require a license. If you’ve got these running, there’s no way an ISP or phone company can stop people from talking to each other.
Last time my fiber went down I still hadn’t configured USB tethering to work in openwrt. I had to connect the router to the mobile hotspot to install packages 😂 So if you have a USB port, don’t put it off for too long.
How did you do it? Simply by installing all the packages mentioned here? https://openwrt.org/docs/guide-user/network/wan/smartphone.usb.tethering
yes that page has all the info. I installed basically everything.
This page has more info for iphone. I didn’t need it for my iphone 6s. https://gist.github.com/brenr/d85592e4d2a66120d12e0ad63cc9b9a2
started usbmuxd and added it to autostart
Then I enabled tethering, connected my iphone (I don’t remember if it was in this order), some new network device showed up. I was expecting it would be called usb0, but in my case it was another ‘eth’ device. Just added it to my wan interface. Worked right away.


